Cooper Menvier SD3 Dokumentacja Pobierz pdf (Strona 14)

Programming SD1+

The SD1+ is now in programming mode. It has no stored

messages or telephone numbers. The passcode is

1234.

Note: If you wish, you can also initialise the unit as

follows:

1. Remove all power from the SD1+ .

2. Fit a jumper to the reset pins (see page ).

3. Apply power to the SD1+.

4. Remove the jumper from the reset pins.

SD1+ Programming

Option 4: Changing Your Passcode

To change the programming of the SD1+ you must first

key in a passcode. In addition, you can use the same

passcode to abort a call if it was started by accident (and

if the SD1+ if programmed to allow you to do so, see

page 25).

When delivered from the factory (or if you have initialised

the unit) the passcode is 1234. Use option 4 to

change your passcode to another set of digits. The

passcode is normally four digits long, but you can make

it six digits long (see page 22).

1. If necessary initialise the SD1+ .

SD1+

2. Key in the current passcode.

READY

3. Press 4, the display shows:

NEWCODE-

4. Press [. The display shows a line of dashes:

----

5. Key in your new passcode, for example 2580.

2580

6. Press [ to store the new passcode and return to

“READY”.

READY

1 2 ... 9 10 11 12 13 14 15 16 17 18

Brak uwag

Cooper Menvier SD3 Dokumentacja Strona 14