Cooper Menvier TS690ID Instrukcja Użytkownika Pobierz pdf (Strona 6)

WEBWAYONE LTD, Unit 11 Kingfisher Court

Hambridge Road, Newbury, Berkshire. RG14 5SJ

00 44 1635 231 514 support@webwayone.co.uk

Galaxy Ethernet Module Emulation - Connections and Configuration (RS485)

Connect the WebWay panel interface RS485 A and B to the Galaxy Dimension connection terminals A and B (Labelled

‘RS485 Line 1’ in the Galaxy Engineer’s Manual PCB Layout). NOTE – Emulation of a Galaxy Ethernet module allows the

SPT to be located anywhere on Bus 1. The SPT must be connected to Data Bus 1 and NOT Bus 2. Bus 1 may be

marked S1 or S2 on Galaxy 18 Models. You will also need RTN connected to a GND in the panel.

Connect the WebWay PWR + and - to the GND and +12V terminals on the Galaxy Panel.

Galaxy Ethernet panel configuration

The majority of Galaxy Ethernet Module settings may remain at default. In the case of Local and Wide Area Network IP

addresses, the WebWay SPT ignores the panel settings. This simplifies installation and provides flexibility with regards to

network address changes. It is recommended that a “loop back” address of 127.0.0.1 is configured as the LAN Address,

Router Address and Receiver Address. The subnet may default to 255.255.255.0.

Go to Menu 56

Select Ethernet Module (Menu 4)

Select Alarm reporting (Option 2)

Select Format (Option 1)

Enter SIA (Option 2), <Level 3(0-4)>

Press Enter

Under the trigger events settings you define which events the panel will report.

Note: it is recommended that the additional Triggers are selected:

Select 10 – Settings <ON> (Default OFF)

Select 18 – Zone Restorals <ON> (Default OFF)

Select Primary IP (Option 2)

Set IP Address <127.0.0.1> (blank by default)

Enter Port number <10001> (default)

Select Account number

Enter <_______> (Site ID)

Go to Remote Access (Option 3)

Select Access Period <Anytime>

Select Mode <Direct Access>

Use escape to return to Engineer Mode. Exit Engineering fully to allow the Galaxy to recognise the SPT as an Ethernet

Comms Module 004. The SPT will also emulate a Keypad, typically Keypad 015 – varies between panels.

Back to panel list

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Brak uwag

Cooper Menvier TS690ID Instrukcja Użytkownika Strona 6